Under the IICRC’s 2026 statement, rising water from rivers or streams is a Category 3 example, and storm water is classified case by case after inspection[IICRC 2026 position statement]. The plan starts from that call.
FEMA advises removing drywall and insulation that floodwater touched and photographing all damage first[FEMA]. In a San Fernando Valley home, that usually means a flood cut along the walls, removal of wet flooring and a full dry-out before anything new goes in.
Typical steps
- Wait for safe entry. Do not go back in until officials say it is safe[FEMA].
- Document. Photos and video of every room.
- Remove. Wet drywall, insulation and flooring come out.
- Clean and dry. Surfaces cleaned, then dried to verified readings.
Do
- Wear rubber boots and gloves[CDC].
- Keep children and pets out of flooded rooms.
First steps before the crew arrives
- Shut off the source. Use the valve at the fixture first. If water keeps coming, close the main shut-off for the house.
- Stay safe. Do not walk through water near electrical outlets or appliances; disconnect appliances before power comes back on[CDC].
- Take pictures. Photograph and video the damage, room by room, before cleanup starts[FEMA].
- Protect belongings. Move rugs, electronics and paper goods to a dry area, and put furniture legs on blocks.
- Start drying fast. The EPA says to dry wet materials within 24 to 48 hours[EPA]. Water left longer moves further into floors and walls.
Do not use a household vacuum on standing water, and do not turn on ceiling fans or lights under a wet ceiling.
Inside a water damage restoration job in the San Fernando Valley
Most restoration work in the San Fernando Valley runs through the same six stages, whether the water came from a split supply line or a winter storm.
- Inspection and moisture mapping. The technician confirms the leak is stopped, then maps how far the water traveled with moisture meters and infrared cameras.
- Water removal. Submersible pumps take out deep water, and extraction units pull water from carpet, pad and hard floors. Mechanical extraction removes water much faster than air drying can.
- Removal of what cannot dry. Materials that will not dry in time are cut out. EPA guidance is that wet materials which cannot be thoroughly cleaned and dried within 24 to 48 hours should be thrown away[EPA flood cleanup guide].
- Structural drying. Air movers push air across wet surfaces while dehumidifiers pull the moisture out of the air. The EPA target is indoor humidity below 60 percent[EPA].
- Cleaning. Surfaces touched by contaminated water are cleaned and disinfected. The CDC says to throw away items that cannot be disinfected, such as wall coverings, cloth, rugs and drywall[CDC].
- Final readings. Drying is finished when the readings say so, not when the surface feels dry. Ask for the daily log.
Where most household water damage starts
- Water heaters. Tanks rust through at the bottom, and relief valves and supply connections drip. In many Valley homes the heater sits in a garage or a closet next to finished rooms.
- Washing machine hoses. Rubber supply hoses crack with age and can release water at full line pressure until someone closes the valve.
- Toilets and supply lines. A failed fill valve, cracked tank or loose supply line can run for hours, often while nobody is home.
- Air conditioning condensate. A clogged drain line backs up the drain pan, and the overflow lands in the ceiling below or on the floor around the air handler.
- Refrigerators and dishwashers. Ice maker lines and dishwasher connections leak slowly under cabinets, where the water can sit for weeks.
- Winter storms and roof leaks. Heavy rain finds its way in around flashing, vents and windows, and contaminated wind-driven rain counts as Category 3 water[IICRC 2026 position statement].
The source matters because it sets the water category and the starting point for moisture mapping.
Leaks you cannot see in the San Fernando Valley homes
On a concrete slab, water does not drain away. It spreads sideways under baseboards, cabinets and flooring into the next room, which is why the wet area on the meter is often larger than the wet area you can see.
Air conditioning is a frequent source. The EPA advises keeping AC drip pans clean and drain lines flowing[EPA], and notes that pans which do not drain can let water into the system[EPA]. When the air handler sits in the attic, an overflowing pan usually shows up first as a ceiling stain.
Places to check:
- Water heater platforms and the floor around them
- Washer supply hoses and the wall behind them
- Sink cabinets and the floor under them
- Inside walls around pipes that leak or condense[EPA]
- Under flooring next to tubs, showers and toilets
LADWP’s leak tips include a simple toilet test: put food coloring in the tank, and if color shows up in the bowl without flushing, there is a leak that should be fixed[LADWP].
What is under the floor matters
Los Angeles City Planning’s history of postwar tract housing notes that these houses often have concrete slab floors rather than raised floors with wood joists[LA City Planning]. Much of the Valley was built in that era, so on many calls the water is on or under a slab.
Older houses are more likely to be raised. The state’s Earthquake Brace + Bolt program, which helps owners retrofit houses on raised foundations, ranks ZIP codes partly by the share of houses built before 1940[Earthquake Brace + Bolt]. In a raised-floor house, a leak can drip through the subfloor into the crawl space and stay hidden.
Either way, the drying plan changes: slab jobs focus on flooring, baseboards and the bottom of walls, while raised-floor jobs add the subfloor, joists and crawl space.
Structural drying in a dry climate
Small leaks found early dry in days; whole-house floods take longer, and the EPA says the drying-out process after a flood could take several weeks[EPA flood cleanup guide]. Either way, the work should start within 24 to 48 hours[EPA].
Outdoor air can help or hurt. EPA guidance is to bring in outside air when it is cold and dry and to dehumidify when it is warm and humid[EPA]. The technician checks conditions inside and out before deciding whether windows stay shut.
Leave the equipment running, keep doors to the drying area closed, and let the technician move it. Turning off air movers at night to cut noise can add days to the job.
When the rain comes all at once in the San Fernando Valley
Most Valley rain falls in a handful of winter storms. In February 2024, the National Weather Service recorded 4.10 inches at downtown Los Angeles on February 4 and another 2.93 inches on February 5, with 12.66 inches for the month, more than 9 inches above normal[NWS Los Angeles].
Storms like that find every weak spot: roof flashing, skylights, sliding door tracks and low garage slabs. Water that comes through the roof soaks insulation and drywall in the ceiling before it shows as a stain.
Keep people out from under a bulging ceiling and away from wet light fixtures, and photograph the damage before the crew starts[FEMA].
Flood safety first
Do not walk or drive through floodwater. The National Weather Service says 6 inches of fast-moving water can knock over an adult and 12 inches of rushing water can carry away most cars[NWS].
If there is standing water inside, be ready to turn off the power, and unplug appliances so they do not shock anyone when power returns[CDC]. Take photos and video of every room before cleanup starts[FEMA].
Flood cleanup by community
- Van NuysFlood cleanup in Van Nuys, CA 91406 and 91405
- Sherman OaksFlood cleanup in Sherman Oaks, CA 91403
- Woodland HillsFlood cleanup in Woodland Hills, CA 91364 and 91367
- Canoga ParkFlood cleanup in Canoga Park, CA 91303
- Sun ValleyFlood cleanup in Sun Valley, CA 91352
- San FernandoFlood cleanup in San Fernando, CA 91340