Postwar tract houses in Los Angeles often have concrete slab floors rather than raised floors with wood joists[LA City Planning], but older homes are a different story. Census figures show that 23% of homes in Sun Valley’s ZIP code 91352, 19% in Valley Village’s 91607 and 33% in the city of San Fernando were built before 1950[U.S. Census Bureau], and many houses from that era sit on raised foundations with a crawl space underneath.
Water from a leaking supply line, a drain or heavy rain can pool in the crawl space and stay out of sight until floors soften or a damp smell comes up through the house. The state’s Earthquake Brace + Bolt program, which helps owners retrofit raised-foundation homes, picks ZIP codes partly by their share of pre-1940 houses[Earthquake Brace + Bolt].
The crew pumps out standing water, pulls down soaked insulation, replaces damaged vapor barrier and runs drying equipment until the joists and subfloor test dry. Wet materials should be dried within 24 to 48 hours[EPA].
Typical steps
- Find the source. Plumbing leak, drain line or surface water.
- Pump out. Submersible pump clears standing water.
- Remove wet materials. Insulation and vapor barrier that will not dry.
- Dry under the house. Dehumidifiers until readings show dry.
Do
- Turn off water if a plumbing leak is the source.
- Keep the crawl space access closed between visits.
Avoid
- Crawling into standing water near wiring[CDC].
- Leaving wet insulation hanging on the joists.
Water damage room by room
- Kitchens. Dishwasher, sink and ice maker leaks run under the cabinets. Toe kicks often come off so air can reach the floor underneath, and cabinet backs are checked with a meter.
- Bathrooms. Toilet overflows, tub drains and shower valves wet the subfloor and the wall behind the fixture. A toilet overflow from the bowl is treated by its source, and a backup through the drain is Category 3[IICRC 2026 position statement].
- Laundry rooms. Burst washer hoses release a lot of water fast, and it usually reaches the next room under the wall. Drain backups bring gray water.
- Garages and water heater closets. A leaking tank spreads across the garage slab and under the wall into the house. Stored boxes on the floor soak up water and should be moved first.
- Bedrooms and living areas. Carpet and pad hold a lot of water. Extraction comes first, then the pad is checked; soaked pad is usually replaced rather than dried.
- Ceilings. Roof leaks and AC overflows wet insulation and drywall above. Wet ceilings can sag, so the area under them is kept clear.
Signs you need water damage restoration, not just a mop
- Baseboards or door casings are swelling
- Vinyl plank or laminate is lifting or cupping
- Stains are spreading on a ceiling or wall
- Water reached cabinets, closets or a hallway
- A drain or toilet backed up
- A damp smell stays after the floor feels dry
These point to water inside the building materials. Surface drying will not reach it.
Water categories and why they change the job
Restoration companies sort water by how contaminated it is, using the IICRC categories. Category 3 is grossly contaminated: sewage, waste line backflows from beyond a trap, seawater, rising rivers or streams, and contaminated wind-driven rain[IICRC 2026 position statement].
It also changes how the crew works. With Category 2 or 3 water, removal and cleaning happen first, under contamination controls, and drying comes after; Category 1 can go straight to drying[IICRC 2026 position statement].
A clean leak does not stay clean forever. Time and temperature can change the category[IICRC 2026 position statement], and a warm house speeds that up.
Water removal and drying equipment used in the San Fernando Valley
- Pumps and extractors. Submersible pumps remove deep water. Extraction wands and weighted tools pull water out of carpet and pad.
- Air movers. Fans set at angles along walls and floors move air across wet materials.
- Dehumidifiers. Remove water from the air. Without them, air movers just push damp air around the room.
- Moisture meters. Measure the water in drywall, framing and subfloor, and confirm when each area is dry.
- Infrared cameras. Help locate wet areas behind finished surfaces, with meters used to confirm.
- Containment. Plastic sheeting closes off the work area, which keeps contaminated water and drying air where they belong.
Earthquakes, water heaters and broken lines
The magnitude 6.7 Northridge earthquake struck at 4:30 in the morning on January 17, 1994, on a buried thrust fault rooted under the San Fernando Valley[USGS]. It left more than 7,000 people injured and 20,000 residents homeless, with property damage estimated at about 40 billion dollars[USGS].
The USGS notes that strong shaking can topple water heaters and break water mains[USGS]. California law requires all residential water heaters to be braced, anchored or strapped to resist falling or moving in an earthquake[California Health and Safety Code 19211], and the Division of the State Architect calls for at least two sets of straps on a typical tank[California DSA].

Once the shaking stops and it is safe to move around, look for running water at the water heater, toilets and sink lines, and close the main shut-off if anything is leaking.
Toilet and drain backups
Sewage is Category 3 water[IICRC 2026 position statement]. Keep children and pets out of the area, do not run fans that blow air from the wet room into the rest of the house, and do not try to dry it in place. Soaked carpet, pad and drywall are removed and the area is cleaned and disinfected before drying.
In the City of Los Angeles, the public sewer main belongs to the city, but the property owner is responsible for the entire sewer lateral, from the building to the street connection. LA Sanitation also says that if any fixture in a home sits lower than the street manhole cover, the property needs a backwater valve, which requires a permit from the Department of Building and Safety[LA Sanitation].
Talking to the restoration company
- What category is the water, and how does that change the plan?
- Where did the moisture meter show water, and how far did it spread?
- What needs to be removed, and why can it not be dried?
- How many dehumidifiers and air movers will run, and how often will someone check readings?
- Will I get a written scope and daily drying logs?
- Can you show your California contractor license?
A good restoration company will answer these without hesitating and will take readings before giving a plan.
After the drying equipment leaves
Keep the final moisture readings and the drying log with your photos. Check the area again over the next few weeks for odors, stains or swelling, which can mean water was missed. The EPA notes that cleanup is not finished until the water or moisture problem itself is fixed[EPA].